Logo SilverFast Logo Logo
Dräger Low Flow and High Flow Oxygen treatment device for the individual supply of 4 people with oxygen or an oxygen mixture
Article number: 55452
Listed in category: Medical Equipment / Oxygen Inhalation > Dräger Low Flow and High Flow Oxygen treatment device for the individual supply of 4 people with oxygen or an oxygen mixture from brakensiek.de
Dräger Low Flow and High Flow Oxygen treatment device for the individual supply of 4 people with oxygen or an oxygen mixture

Manufacturer and owner of the Brand:
Dräger Medical Germany GmbH
Moislinger Allee 53-55
23558 Lübeck

The devices were manufactured for the German Armed Forces under the number TDV 6515 / 001-12

The system works as follows:

You rent an oxygen cylinder, e.g. from Linde Gas, and screw the unit to the cylinder.

The unit has a pressure reducer for pre-regulation of the 4 outputs. Downstream there are 4 extraction valves for the individual regulation of the 4 outlets for oxygen. A low flow single-use oxygen mask / ventilation mask without humidifier or a high-flow single-use oxygen mask / ventilation mask with humidifier are connected to the outputs. However, these are not part of the offer.

This takes place in several stages.

Level 1: oxygen saturation of the blood below 97%
A low flow low flow single-use oxygen mask / ventilation mask without humidifier is connected to the output and then measured whether the oxygen saturation value improves. This is already possible with the small oxygen bottle named in the text. Pure oxygen can be administered or just a mixture up to a maximum of 2 liters / minute. Up to 2 liters / minute can still be done without humidification.

Level 2: Oxygen saturation of the blood> = 97% is no longer achieved with level 1.
like 1 only that you connect a high flow disposable oxygen mask / ventilation mask with humidifier. You can see such images in India at the moment. But then a huge oxygen bottle is used. An administration of more than 2 liters / minute may only take place in the hospital.

Level 3:
If level 2 does not work, a mechanical IPPV official is required. The device cannot do that! The device was developed for the German Armed Forces by Dräger.

The following elements are therefore required according to the drawing:

1) Oxygen cylinder                   - not included in the scope of delivery / if you rent it in the usual way - you will find detailed information below

2) Bottle valve                    - not included in the scope of delivery / The bottle valve is located on 1)
3) Pressure reducer             - included in delivery
4) Control handwheel             - included in delivery
5) Content pressure gauge       - included
6) Flow meter                    - included
7) Supply hose                   - not included in the scope of delivery / part of a disposable mask
8) Additional air valve              - not included in the scope of delivery / part of a disposable mask
9) Valve box                          - not included in the scope of delivery / part of a disposable mask
10) Exhalation valve             - not included in the scope of delivery / part of a disposable mask
11) Inhalation mask              - not included in the scope of delivery / part of a disposable mask
12) Headband                    - not included in the scope of delivery / part of a disposable mask
13) Breathing bag                    - not included in the scope of delivery / part of a disposable mask
14) Closing cap                    - included in delivery
15) Air intake invector             - included
16) Withdrawal valve              - included in delivery
17) Distribution piece             - included in delivery


Necessary consumables beyond the oxygen cylinder:

Low flow official disposable masks with hose
High flow official masks with humidifier with hose
Reusable systems are not recommended.

A test must be carried out before each use of the device!

If necessary, the seal or the sealing ring, for example, should be replaced after the device has been used.

The valve must be tested in the form of an STK after 12 months at the latest.
This means that stock parts, e.g. sealing rings, must be replaced immediately after the damage has been determined

Minimum requirement for oxygen cylinder:

Length: approx. 50 cm (with bottle valve)
Diameter: approx. 14 cm
Volume: 5 liters
Filling pressure: 200 kp / cm² (196 bar)
Test pressure: 300 kp / cm² (294 bar)
Oxygen supply: (with a full bottle) approx. 1000 liters

Weight of the usual oxygen cylinder:

with bottle valve: approx. 50 cm (with bottle valve I)
Connection piece: R 3/4 "external thread (DI N 477)

the valves are disinfected and welded sterile.

Not new according to our terms and conditions







Ampel gebrauchtprodukt     last update:   06.07.2021
Topimage
worldprintmarket.com

Visit the new marketplace for prepress, press und postpress: www.worldprintmarket.com
Optimize your cash-flow by selling your no longer required machines.
Intellitrax

X-Rite IntelliTrax System - automatic spectral color measurement system for sheet, and roll-feed printing units and package-printing units according to PSO for Heidelberg, MAN Roland, KBA, Ryobi, Komori, Wifag, Mitsubishi. In at least 15 seconds you will measure the print control strip and receive a graphic printout of what to change in which zone to meet your deposited standard e.g. PSO.
matchflow adjust

With Matchflow-adjust you can share a pdf-document over the internet for detailed checking and annotation. In this document all project-members (depending on their access-rights) can acquire comments and modifications. By using the "Generated Print Report Button", you generate an new PDF which contains annotation number, username, date, annotation text and type. All comments are saved in a database. So the whole coordination-process is reconstructable at any time. You will save proof and dispatcher costs an maybe need only one final proof. We recommend to insert a flat PDF which can be written from any common workflow system. AGFA Apogee, Heidelberg Prinect, Creo Prinergy, Di Plot, if this function is enabled.
FireWire
SilverFast

Order your FR1SX Firewire-Adapter offer here.
A CD-ROM with actual SilverFast AI Studio + HDR Demo-Version is included in delivery. Please specify your scanner type. We are sure that only an perfect maintained Linotype Hell/Heidelberg Chromagraph S3300/S3400, Nexscan F4100/F4200, Primescan 7100, 8200, 8400 and Tango/Tango XL sowie Topaz HighEnd scanners provide quality and are able to reach Delta E 1 scales after reprofiling. Therefore we provide spare parts and preventive service. Service contracts are possible. After service we peform an new DIN VDE 701 report.
PDF

Dowload and print this article as PDF data sheet: Data Sheet Dräger Low Flow and High Flow Oxygen treatment device for the individual supply of 4 people with oxygen or an oxygen mixture
Terms and conditions:
Please only contact us via our registration form and only if you are a business person yourself. Every offer is subject to prior sale and includes your acceptance to our terms & conditions Terms and conditions (AGB) All logos and trademarks on this site are the property of their respective owners.

You will always receive an invoice including tax, which can be paid via wire transfer, in advance or cash. If you register on paypal, you may also pay by charging your paypal account with your credit card. If you are an EU member and you have a validated tax number which can be validated here: VIES VAT number validation / MwSt.-Informationsaustauschsystem MIAS) Validierung der MWSt.-Nummer then you pay tax-free. If you are from outside the EU, you can only pay tax-free, if the export is done with the transport company, called 'Schenker'. If you are not using 'Schenker', we cannot guarantee that we will get the export confirmation in time. In that case, you have to pay tax and you get it.

The website was generated by matchflow and the PDF version was released by matchflow-adust: communicate, control, confirm. Matchflow-adjust provides browser-based PDF correction and PDF annotation with web2print features.
Login | Subscribe to Newsletter | Imprint | Terms and Conditions(AGB) | Contact | Links | Remote Control Win Mac| Stocklist | Purchase List |